IOLITEi-1xACC Signal Conditioner
Single channel signal conditioner for IEPE sensors with high-precision isolated front end and Ether CAT bus on the back
About the IOLITEi-1xACC
The IOLITEi-1xACC is a singel channel signal conditioner for IEPE sensors with high-precision isolated front end and EtherCAT bus on the back side.
Key features
- 24bit ADC, 40 KS/s max. sample rate
- -100 dB noise floor, 100dB spurious-free dynamic range
- Singal and power isolation from EtherCAT to front-end
- TEDS communication
- EtherCAT bus, daisy-chaining with single cable up to 50 m device-device
- DEWESoft X3 software support
Typical applications
- Machine vibration monitoring
- Bearing fault detection
- Modal structural analysis
Installation
Devices are daisy chained with a standard network cable. It is recommended that the cable is shielded (SFTP, CAT5e) and has a minimum 24 AWG wire thickness. The cable must have 4 wire pairs. The maximum distance node-to-node is 50m.
Power supply: Passive PoE power injector is necessary for merging the EtherCAT signal and power into a single cable.
Behöver du den här sensorn för ditt nästa projekt?
Begär en offert idag eller lämna dina uppgifter för att få mer information från en av våra experter.
Produktnedladdningar
Gör som du vill
Inte exakt vad du letar efter? Vi erbjuder standardprodukter men kan också hjälpa dig med en skräddarsydd sensor eller en komplett mätlösning. mätlösning. Kontakta oss för rådgivning eller budgetpriser.
Prata med en expert