FCP12AC Single-turn Potentiometer

Conductive plastic - Bushingmount

Nyckelfunktioner

Conductive plastic
Dimensions D x L (mm): 13 x 10
Standard Resistance Range 1Ωto 10 kΩ
Independent Linearity (± %): 2.0 to 1.0
Mechanical travel (+10° 0°): 360°
Electrical travel (±5°): 300° ±5°

About the FCP12AC Single-turn Potentiometer- Conductive plastic (Bushingmount)

The FCP12AC is a low-cost 1-turn potentiometer with rear extended pin terminals.

Special Specifications Available

Extra taps (available up to 1 tap), shaft with front and rear extension (rear shaft with 1mm dia. and 10mm length), with stopper (rotating angle becomes 310º and stopper strength is 0.3N·m [3kgf·cm]), special electrical travel, shaft dia. (ø3.175mm) bushing with inch dimensions, special machining on the shaft.

Behöver du den här sensorn för ditt nästa projekt?

Begär en offert idag eller lämna dina uppgifter för att få mer information från en av våra experter.

Prata med en expert

Produktnedladdningar

Fcp12ac single turn potentiometer en

Gör som du vill

Inte exakt vad du letar efter? Vi erbjuder standardprodukter men kan också hjälpa dig med en skräddarsydd sensor eller en komplett mätlösning. mätlösning. Kontakta oss för rådgivning eller budgetpriser.

Prata med en expert

Tekniska specifikationer

Specifikation	Värde
接触电阻变化	Within 3% C.R.V.
Dielectric strength	1 minute at 500 V.A.C.
Electrical travel	300º ±5º
Independent linearity tolerance	Standard Class ±2.0% precision Class ±1.0%
Insulation resistance	Over 1,000MΩ at 500 V.D.C
Mass	Approx. 8g
Mechanical travel	360º (Endless)
Output smoothness	Within 0.1% against input voltage
Power rating	0.2W
Resistance temp. coefficient	±400p.p.m./ºC
Resolution	Essentially infinite
Special practical resistance values	500, 20k, 50k, 100k (Ω)
Standard resistance values	1k, 2k, 5k, 10 k (Ω)
Starting torque	Within 2mN·m (20gf·cm)
Starting torque	Within 2mN·m (20gf·cm)
Total resistance tolerance	Standard Class ±15% (L) Precision Class ±10% (K)